Lumber Jack BS228, Инструкция по безопасности и эксплуатации, Страница: 18 / 26

BS228 16
MAINTENANCE AND SERVICE
– Now tighten the drive belt knob.
– Now check the belt is tensioned correctly, do
this by pulling the belt half way between the
pulleys and it should approx. 10mm.
– If it needs adjusting loosen the motor locking
bolt and turn the motor anti-clockwise to loosen
the belt and clockwise to tighten the belt.
– When the correct tension is achieved tighten
the motor locking bolt.
Changing the Blade
– Remove the guide rail from the table.
– Open the upper and lower covers.
– Set the upper blade guide to its lowest
position.
– Loosen the saw blade tension knob until the
blade has slackened so that the blade can be
removed.
– Remove the blade and clean both top and
bottom pulleys before installing the new blade.
– Tighten the saw blade tension knob, and
replace the guide rail and close the top and
bottom covers.
– Now align and tension the blade then adjust the
upper and lower blade guides as described earlier
in this manual.