Lumber Jack BS228, Инструкция по безопасности и эксплуатации, Страница: 16 / 26

BS228 14
OPERATION
Operation
Before any work on the machine itself, remove
the mains plug from outlet.
Switch action
– Set the upper guide as describe previously
approx. 3mm above the height of your work
piece.
– Position the rip fence/mitre gauge as
needed/required. Please note the rip fence can
be positioned on either side of the blade.
– Turn on the LED light if required and start the
machine.
– Wait for the motor to reach full speed then
push through your work piece, using the push
stick to stop accidental touching of the blade.
– Turn of machine and LED light.
Using miter gauge
The miter gauge is inserting into the table slot
from the table front edge.
For miter cuts, the miter gauge can be turned to
60º in both directions.
Switch
Led light switch
To set a miter angle: loosen lock knob by turning it
counter-clockwise.
Warning: When cutting with miter gauge, the
lock handle must be firmly tightened.
Using push stick
The push stick serves as an extension of the hand
and protects against accidental contact with saw
blade.
When the push stick is not used, it can be stored
on the hook provided at the band saw frame.
Replace push stick if damaged.
Miter gauge
Lock knob
Push stick