Lumag BSF15, Руководство оператора

Страница: 14 / 20

9
Stump Grinder
Prepare the grinder at the stump.
Place it into position with the cutting wheel near the top edge of the stump.
Removing roots
1. Make sure the throttle is set to fast, the cutter wheel will accelerate to
cutting speed.
2. Swing the cutting wheel to one side, then lower it into the nearest roots that are
buried at the foot of the stump.
3. Swing the cutting wheel before each sweep, until the roots are
sufficiently removed.
4. Raise the cutting wheel until the centre of the cutting wheel is just above the top
of the stump.
5. Allow the cutter wheel to stop, release the brake and reposition the machine.
6. Lock the brake again.
Cutting the full stump
1. Make sure the throttle is set to fast. The cutter wheel will accelerate to
cutting speed.
2. Direct the cutter wheel against the stump, beginning with the nearest top corner
of the stump, and steadily sweep it across the stump left and right, cutting away
1/2 inch of wood with each sweep.
3. Raise and lower the cutter wheel between sweeps by lowering and raising the
control handle.
4. Roll the machine forward and back, by pushing and pulling on the control
handle. To do this, release the brake. Relock it when the machine has been
repositioned and continue cutting.