Lumag BSF15, Руководство оператора

Страница: 12 / 20

7
Stump Grinder
1. Only fill the fuel tank to a level 15mm lower than the top of the fuel tank. Do
not overfill.
2. Use the dipstick to check the oil level. Use 10w-30/ 10w-40/ 15w-30/ 15w-40
non-synthetic engine oil. Fill to the correct level before use.
The engine is shipped without oil. Fill to the correct level before use. Operating the
engine with no oil or oil at a low level will destroy the engine- this is not covered
under warranty.
1. Lock travel wheel by pulling brake lever fully back.
2. Make sure throttle is in slow position.
Do not allow the rope to snap back, return it by hand to prevent damage to the
starter.
3. If the engine is cold, move the choke lever to the closed position.
4. Raise the cutter wheel 4 to 5 inches off the ground by pushing downwards on the
handle bar, hold it in that position.
The next step may cause the cutter wheel to rotate, keep everyone away.
5. Pull the starter rope lightly until resistance is felt then pull briskly.
6. Move the choke lever to the open position.
The next step causes the cutter wheel to rotate, keep everyone away.
7. Move the throttle to fast. if the engine is cold, allow the engine to idle(throttle set
to slow) for a few minutes before cutting.
Dipstick Cover