STEP 2 - PLACE THE LUCI SMARTFRAME
Tools Required
- LUCI SmartFrame™ (A)
- M5 x 10mm Screws (N)
- 3mm Allen Wrench
2C
5
STEP 1 - PREPARE WHEELCHAIR BASE
Unplug the male RNET cable from the power module
(Figure 2A). Re-route the cable so that it exits the side
of the wheelchair base, gently pulling out about 6”
of slack cable. Loosely insert one M5 x 10mm flange
screw (N) into the LUCI Subframe on each side of the
wheelchair (Figure 2B). Slide the LUCI SmartFrame (A)
onto the wheelchair, lining up the front mounting holes
(Figure 2C). Clip the frame onto the standoff (Figure
2D) on each side and insert an M5 x 10mm flange screw
(N). Tighten with a 3mm Allen wrench. Let the sides of
the LUCI SmartFrame (A) rest on the loosely inserted
screws to keep it up out of the way while connecting the
RNET cables (Figure 2E).
2D
2B
2A
UNPLUG RNET
LOOSELY INSERT
2E
REST SMARTFRAME
ON SCREWS
CLIP FRAME ONTO
STANDOFF
