Installing the WavePOINT-II
Powering-up WavePOINT-II
2-12
WavePOINT-II - Quick Installation Guide
Powering-up WavePOINT-II
2
The WavePOINT-II power supply accepts any input AC voltage in
the range of 100-240 VAC.
!
WARNING:
For your own safety, use only the power cord supplied with
the unit. Insert it in a grounded AC wall outlet.
When using the unit in combination with outdoor antennas,
the grounding of the AC wall outlet must be connected to
the safety grounding system of the outdoor antenna
system and the WaveLAN Lightning Protector.
When powered on, the WavePOINT-II unit will perform start-up
diagnostics characterized by a LED sequence. The WavePOINT-II
LEDs will change color in the range Amber, Red and Green.
When finished (after approximately 60 seconds) the WavePOINT-II
unit will start bridging operation characterized by the LED activity
as listed in Table 2-1 below.
Table 2-1
LED Activity Table:
If the WavePOINT-II does not switch to normal operation within two
minutes, please consult the troubleshooting section of the
WaveMANAGER IEEE User’s Guide.
LED Definition
Activity
1
1
LED activity will only occur when there is network activity on the
corresponding WavePOINT-II interface.
Description
Power
Green
Power enabled
Ethernet
Flicker Green
Ethernet LAN activity
WaveLAN A
Flicker Green
WaveLAN activity on socket A
WaveLAN B
Flicker Green
WaveLAN activity on socket B
A
B
wp2_c.book Page 12 Thursday, September 23, 1999 6:24 PM
