Lucent Technologies Victory WP-93936, Руководство по эксплуатации продукта

Страница: 50 / 116

Lucent Technologies Victory Class Batteries WP-93936
6 - 12 Installation Issue 1 May 2000
Cell Installation Guidelines, continued
Arrangement,
continued If the aisle is too narrow to allow access to the rack from the front, it
may be necessary to load the rack from the end. Lubrication is typically
not required since the plastic rail covering provides a low friction
surface for sliding the cells. If a lubricant is deemed necessary,
unscented talcum powder may be used sparingly. The talcum powder
may be removed with a cloth dampened in water. An equally acceptable
method for lubrication is to use a small amount of water applied
sparingly to the rail covers. Do not use any other solvents.
For Seismic racks, place spacers (supplied with battery racks) between
cells. Add front and end restraining rails and install front-to-back
restraining rail tie rods for Seismic racks. End rails should be placed
within 1/8 inch from end cells.
After cells have been placed on the rack(s), remove the orange shipping
vents and install the flame arrestors and dust cover vent assemblies,
which are provided in the accessory kit.
Warning
Do not use wire pulling compounds, oils, grease, or any other
material not specifically authorized by Lucent Technologies in
writing, as these may contain additives that could damage the plastic
containers.
Caution
Where multiple standard type racks are installed end-to-end, no more
than one-eighth inch of cell length should rest over a support rail that
is not rigidly spliced.
Never move or adjust a rack with batteries loaded on it.