Lucent Technologies Stinger, Руководство администратора

Страница: 55 / 374

Administering a Stinger System
Displaying basic system information
Stinger® Administration Guide 1-33
admin> line
Or, you can use the following command to specify that the line-status information
appears in the top of the window, replacing the general status information:
admin> line top
You can display information about all lines installed in the system if you wish, but
the default is to show information only about enabled lines. To display the status of
all lines, enter the following command:
admin> line all
When you enter the line command, the system puts the window in line-status mode
and displays the following message, which indicates the key sequences for displaying
additional information in the line-status area:
[Next/Last Line: <dn/up arw>, Next/Last Page: <pg dn/up>, Exit: <esc>]
The Down Arrow and Up Arrow keys display the next and previous lines,
respectively, in the list. The Page Down and Page Up keys display the list a screen at a
time.
Line status information includes the following identifiers and codes:
Line identifier in the format shelf slot line
Two-character code indicating the line’s link status
Single-character code indicating channel status
Single-character code indicating channel type
For additional information about identifiers and codes, see the Stinger Reference .
When the line-status-mode message is displayed, the system prompt does not appear
at the bottom of the window. Press the Escape key to exit this mode and return to the
system prompt.
Log message information
With the default settings in a
user
profile, the bottom area of the status window
initially displays the most recent message from the Stinger log buffer. The number of
system event messages stored in the log is set by the
save-number
parameter in the
log
profile.
The first line of the event log window shows the log entry number (M: 00 through M:
N , where N is set in the save-number parameter of the log profile), the level of
message, and the device on which the event occurred. The last line shows the date
and time when the event occurred.
The middle of the window displays the text of the most recent message.
If the status window is not already displayed or if you want to scroll through the log,
use the
log command:
admin> log
If the Status window is not displayed, the log command opens it and displays the log-
mode message below the Status window. (If the Status window is already open, the
log command just displays the message.)
[Next/Last Conn:<dn/up arw>, Next/Last Page:<pg dn/up>,Exit: <esc>]