Installation Instructions
2 | P a g e v 1 . 1 ( 0 8 / 2 0 1 8 )
Installation directions
1.
Remove all packaging material from the product and be careful not to throw away accessories that may be hidden
within the packaging material.
2.
Turn the power off before commencing the installation. (Fig.1)
3.
Mark the water level of the pond. The maximum depth must not be over 2 metres. (Fig. 2)
4.
Use the mounting bracket as a template to mark the screw positions on the mounting surface then drill holes for
the screws (Fig.3)
NOTE: If the pond is made from fibre glass, drill into the base of the pond can cause leaks. Paver, brick or
rock can be used as mounting surface in this case. Ensure they are heavy enough to weight down the
luminaire.
Ensure the screws and anchors used are suitable for the mounting surface and the surrounding environment.
5.
Install the luminaire to the mounting surface by tightening the 2 screws. (Fig.4)
USING LUCCI WIRING KIT AND/OR LUCCI TRANSFORMER (both sold separately)
6.
Use the quick connector to connect the luminaire to the wiring kit and/or the transformer (SKU# 220818, 220819,
220829 – sold separately).
NOTE: The transformers are rated for 80VA, 28VA and 10VA load respectively. (Fig.5)
NOTE: The quick connectors are rated IP65, both must not be immersed in the water. Proceed to step 7.
USING OTHER WIRING AND TRANSFORMER (not included)
6.
Remove the 12V bi-pin quick connector for hard wiring or alternative wiring method and power supply system if
necessary.
Ensure that the wires are secure and no bare wires are exposed. Ensure all wiring and the transformer used are
appropriately rated and suitable for the location used. If unsure, please contact a licensed electrician.
7.
Fill the pond with water. The water level must not be over the maximum rated depth of 2 metres. (Fig.6)
8.
Turn the power on and test the luminaire is operating correctly. (Fig.7 and 8)
