Futura ECO Installation Instructions
11 |
P a g e
AFTER INSTALLATION
WOBBLE:
NOTE: Ceiling fans tend to move during operation due to the fact that they are mounted on a rubber
grommet. If the fan was mounted rigidly to the ceiling it will cause excessive vibration. Movement of a
few centimeters is normal and does not suggest any problem.
TO REDUCE THE FAN WOBBLE:
Please check that all screws which fix the mounting bracket and
down rod are secure.
NOTE: This fan has been precision balanced at the factory and will not need to be balanced again.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in
fan motor noise. This is normal. Please allow a 24-hour “breaking-in” period, most noises associated
with a new fan disappear during this time. All electric motors are audible to some extent, please note that
this is not a product fault, and as such is not covered under warranty.
CARE AND CLEANING:
•
Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free
cloth to avoid scratching the paint finish. Please turn power off when you do so.
•
Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create
the possibility of an electrical shock.
•
The motor has a permanently lubricated ball bearing so there is no need to oil.
NOTE: Always turn off the power at the mains switch before attempting to clean your fan.
Ceiling Fan model
Rated Voltage
Rated Power
(motor)
Rated Power
(lamp)
Futura ECO 48” with light
220-240 VAC
60W
2 x Max.42W E27 halogen bulbs or
2 x Max.15W E27 CFL Spiral
Futura ECO 52” with light
220-240 VAC
70W
2 x Max.42W E27 halogen bulbs or
2 x Max.15W E27 CFL Spiral
Futura ECO BIG 52” with
light
220-240 VAC
70W
2 x Max.42W E27 halogen bulbs or
2 x Max.20W E27 CFL Spiral
TECHNICAL INFORMATION
