Airfusion QUEST II Installation Instructions
7 |
P a g e
HANGING THE FAN
Lift the fan assembly onto the mounting bracket. Ensure the key slot (A) of the hanger ball is positioned on
the key pin (B) of the mounting bracket (C) to prevent the fan from rotating when in operation. (Fig.5)
LIGHT KIT INSTALLATION (For models with fan light kit only)
1.
Remove the decorative cover from the shaft at the base of the fan.
2.
Pull the L and N wire out from the shaft.
3.
Insert the L and N wires through the light connector (1).
4.
Install the light connector onto the shaft and secure firmly with a spanner.
5.
Install the light base (2) onto the copper connector (1) and secure by tightening the nut (3).
6.
Connect the L and N wire from the fan to the terminal block (4).
7.
Remove the nut (6) from the terminal block (4).
8.
Install the wire protective cover (5) onto the terminal block (4) and secure with the nut (6).
The wire
protective cover(5) must cover the L and N wires from the motor shaft to the light kits terminal block (4).
9.
Install a globe (not included) into the lamp holder. Do not exceed the maximurm wattage rating.
10.
Install the glass shade (7) onto the lamp base (2). Ensure it is secure using three spring clips (8).
Fig. 6
Fig. 7
Fig. 5
