Airfusion Climate Installation Instructions
8 |
P a g e
Transmitter/Receiver pairing for ceiling fan 2:
•
Turn off the mains supply to the receivers of both ceiling fans 1 and 2.
•
Slide the cover of the battery compartment of the transmitter to access the DIP switches. This will be
transmitter 2.
•
Change the position of the DIP switches in the remote transmitter 2, so that it will be different to transmitter
1. Fig. 10
•
Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.
•
Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
•
Press and hold the SET button of
transmitter 2
for 8-10 seconds within 60 seconds of switching the
power to the receiver of ceiling fan 2.
If the fan has light kit attached, the light will flash on and off to indicate the paring process activated.
The fan operates at highest speed in REVERSE mode automatically for approximately 2 minutes and
then operates in FORWARD mode for approximately 2 minutes. During the paring process,
DO NOT
TOUCH THE REMOTE FOR 4-5 MINUTES.
•
Now the transmitter should be paired with the receiver of ceiling fan 2. Turn ON/OFF or change the speed
of the ceiling fan 2 by the transmitter to check operation.
Fig. 10
