Airfusion Climate Installation Instructions
12 |
P a g e
AFTER INSTALLATION
NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet. If the fan
was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few centimetres is quite acceptable
and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE:
Please check that all screws which fix the mounting bracket and down rod are secure.
BALANCING KIT:
A balancing kit is provided to balance the ceiling fan on initial installation. Please refer to the instruction
on how to use the balancing kit.
The balancing kit can be used to assist re-balancing should the ceiling fan become un-
balanced again. Store your balancing kit away after installation for future use if required.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and frequency
signals superimposed in the electricity for off-peak hot water control, may cause a change in fan motor noise. This is
normal. Please allow a 24-hour “settling-in” period, most noises associated with a new fan disappear during this time.
The manufacturer’s warranty covers actual faults that may develop and NOT minor complaints such as hearing the motor
run – All electric motors are audible to some extent.
CARE AND CLEANING:
NOTE: Always turn OFF the power at the mains switch before performing any maintenance or attempting to
clean your fan
.
•
Every 6 months periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free
cloth to avoid scratching the paint finish. Please turn off electricity power when you do so.
•
Do not soak or immerse your ceiling fan in the water or other liquids. It could damage the motor or the blades and
create the possibility of an electrical shock.
•
Ensure that the fan does not come in contact with any organic solvents or cleaners.
•
To clean the fan blade, wipe with only a damp clean cloth with NO organic solvents or cleaners.
•
The motor has a permanently lubricated ball bearing so there is no need to oil.
SAFETY PRECAUTIONS FOR BATTERY:
-
WARNING –
Keep new and used batteries away from children.
-
CAUTION –
Do not ingest battery—Chemical burn hazard.
-
Always use
1 x 23AE 12V
battery type with this ceiling fan remote controller.
-
Ensure the batteries are inserted with the correct polarity.
-
To prevent false operation during battery insertion or replacement, this ceiling fan must be
disconnected from the supply mains.
-
Remove batteries from the product when not in use for long periods of time.
-
Batteries must be removed from the remote transmitter before it is discarded.
-
Dispose of exhausted batteries immediately and safely (so they cannot be retrieved by children). Flat
batteries can still be dangerous. Contact your local council to safely dispose of the battery.
-
Regularly check the product and make sure the battery box lid is correctly secured. If the battery
compartment does not close securely, stop using the product and keep it away from children.
