Spare part list
Floor watering system
Copyright © 2018 Lubing System - All rights reserved
14
3.6.6 Assembly of the pipe holders
Measure and mark the distance for the upper holder above the supply unit. Measure and
mark the distance for the upper holder at the end. Then mark the horizontal connection
between these points with a chalk line. Attach the upper holders at a distance of max. 75
cm (30 in). The distance from the end should be 37.5 cm (15 in).
Attach every upper holder with two screws and washers.
3.6.7 Assembly of the riser
Connect the pump to the spraying pipe. The enclosed 2.5 m long PVC pipe must be cut to the desired length on
site. For a recommendation on the length cutting of the individual parts, see the following figure.
Cut and bond the entire piping system from the pump to the spraying pipe. Then place the pump cover on the
supply unit in order to prevent dirt and splashing water at the pump. Observe the arrangement of the construction
units as in the sketch.
The float valve in the housing should be connected to the pressurized water at a later time, so that the system will
not be filled by accident. Ensure that the float of the valve can move freely.
WARNING
Ensure straight cuts when sawing the pipes. Then clean the front of the pipes and deburr them to 15°.
Contamination or splinters in the hose system may considerably reduce the system’s efficiency and/or
cause damage!
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
lubingsystem.
com
