P A D - C L I M A T E - S Y S T E M
Assembly instruction and operators manual
Operating instructions
18
4.
Operating instructions
Concept of evaporative cooling
4.1.
To offset periods of extreme temperature that affect in-house environments and
therefore production, LUBING Pad-Climate-Systems are used with outstanding suc-
cess. The benefits of evaporative Pad cooling are obtained by moving large quanti-
ties of air through water-saturated Pads. The resulting evaporation of water will lower
the air temperature. This method of cooling can provide dependable relief from heat
stresses in periods of hot weather. Suited for all geographic locations, a LUBING
Pad-Climate-System delivers the greatest economic benefits in areas where higher
temperatures during longer periods of time are normal.
LUBING Pad-Climate-System comprises the following components:
•
Supply Unit
•
Middle elements
•
End kit
Prior start up
4.2.
•
Connect the float valve to a suitable
water supply. WARNING! Check to
make sure that all locks are secured
before each use.
•
If needed, adjust the floating valve
swimmer to the desired water level
by turning the adjusting screw.
•
Please read through the “
Original
Installation and Operating Manual
”
carefully before you use the “
AQUA
LUBING
11
” pump for the first time.
Connect the pump as prescribed
from the manufacturer.
•
Water quantity and distribution can
be adjusted by infinitely turning to
the Deflector. Adjust the holes of the
Water Distribution Pipe in an angle
of 30 degrees to the outside.
•
To reach the right water quantity, adjust the Ball Valve to a water cullum
(which streams out of the holes) of 22-25 cm (8-10 in) height over the
Water
Distribution Pipe.
