5.4.6 COMM. SETUP SUBMENU
ATTENTION!
ENTER
Formatting cancels any data contained in the Card.
In the Memory Card submenu, press
.
Note:
in the event of an error or a Card fault, if there is no Card in the slot or if the Card is removed during
formatting, the display shows the following message:
This submenu allows access to the setting of communication with other units via the serial ports.
Note:
Dump Out Preset
Incoming Dump
the
and
functions are an exception, as they're controlled directly in
the
menu.
PRESET
PRESET Change RX
Allows to accept or ignore the PRESET Change command sent via the serial ports from a computer or another
MAXIDRIVE3.4+ when it loads a PRESET.
The settings can be:
Ignore PRESET Change commands received. Accept and execute PRESET Change commands.
Press ENTER.
The system formats the Card until it communicates that it has completed.
During formatting, the system automatically stores the *Default* PRESET in all the 128 CARD memory areas.
Note:
since the system must always be configured, there are no empty memory areas. All the User and
Card
which
areas not yet used by stored user data are automatically occupied by the *Default* PRESET,
contains a standard start configuration with all the values of the various parameters at zero.
The Format Card page appears
This operation only requires a few seconds.
The Card is ready to be used.
Comm. Setup
Preset Change RX
Comm. Setup
Preset Change RX
Preset Change RX
ID Select
F o r
a t
C a
m
d
r
F o r
a t
C a
m
d
r
F o r
a t
m
t i n g . . .
F o r
a t
C a
m
d
r
F o r
a t
m
D o n e
!
F o r
a t
C a
m
d
r
F o r
a t
m
E r r o r
!
C
m
o
. S
t u p
m
e
P
e
r
e t
C h a
s
n g e
R X
A c c e p t
P
e
r
e t
C h a
s
n g e
R X
I g n o r e
5. THE MENU MAP CONFIGURATION DESCRIPTION
27
