LSI LASTEM Alpha-Log, Руководство пользователя

Страница: 29 / 116

Alpha-Log – User manual
LSI LASTEM SRL INSTUM_03388 Page 29 / 116
1. Actions (1) .
2. Select one Local action (switched power output)
3. Select one Remote action (2) .
4. Press [Edit] (3) .
5. Select the mode of activation: AND/OR (4) .
6. Select one or more logic statuses involved
in this action
(5) .
7. Enter the remaining parameters.
In the example on the right, parameters
refer to e-
mails. In particular: recipient’s e -
mail address (6) , elements (7) to enter in
the e-mail. The program shows a preview
of the selected items
(8) .
8. Press [Ok] (9) .
FastMode and MQTT modes setup required the selection of the logic name only.
For further information, see §4.1.9.
Alpha-Log DLALA0100 requires a minimum power supply of 12 Vdc to supply 10.5 Vdc to the
actuated outputs.
Alpha-Log DLALA0100.1 supplies the actuated outputs with a voltage approximately 0.3 Vdc lower
than the power supply on terminals 13 +, 14 + and 15-, 16-.
2.2.10 Saving and uploading configuration file to Alpha-Log
Press [Save] in the Toolbar and press [Ok] . If a check of the connectivity parameters is required (the PC must
be connected to the Internet), press [Yes] and then [Continue] .
3DOM will ask if it is needed to send the configuration to the instrument. If yes, press [Yes] and confirm with
[Ok] , or [No] to send it later.
During the configuration saving process, 3DOM verifies that it does not contain errors or
inappropriate choices. Whenever these are still acceptable / tolerable by the system, the program
generates a warning message, however it will be possible to save the configuration.
In case of critical errors 3DOM does not allow configuration saving and indicates the corrective
action to be taken to proceed. In case of important changes, the program asks for confirmation of
the
choices made.
While uploading and saving the configuration in Alpha-Log, 3DOM shows a percentage progress
bar. In the event that an unexpected event (e.g. communication interruption) disturbs this phase,
Alpha Log detects the irregularity and restarts itself with the last valid configuration.
To send the configuration via SSH (Alpha-Log is connected to the PC directly via Ethernet or Wi-Fi):
1. Select the serial number of the instrument and the required configuration from the list Instruments .
1
2
4
5
3
6
7
8
9