Maintenance Functions
Caution:
The following features are not normally adjusted unless directed by LRS.
Paging Types in Mixed Systems
When using different types of pagers, be sure that alphanumeric pagers are numbered higher than the non-
alphanumeric pagers.
Setting Crossover Points
This function is used to set the crossover points where non-alphanumeric end and alphanumeric pagers
begin. Crossover points must be set using the following rules:
The default crossover point for Staff Pagers is 50.
• 50 and above are Alphanumeric Pagers.
• Below 50 is for Star Pagers.
The default crossover point for Guest Pagers is 1000.
• 1000 and above for Alphanumeric Coasters.
• Below 1000 for Coaster Call and Paddle pagers (AdverTeaser).
To Change the Crossover Points:
1. Press SETUP and enter Password.
2. Press 1) System.
3. Press F2 (DN) until display shows 1) POCSAG.
4. Press 1 (1: POCSAG).
5. Press F2(DN) until 2)POCSAG Start is displayed.
6. Press 2) POCSAG Start.
7. For Guest Alphanumeric Pagers, press 1) Guest and type in the new POCSAG start number from 1 –
9999.
8. For Staff Alphanumeric Pagers, press 2) Staff and type in the new POCSAG start number 1-9999.
Choose number from 1 – 9999. Press ENTER to keep a default value - 50.
Station ID
Station ID is often confused with System ID. This function is used where more than one station of the same
establishment may be paging staff pagers. The indicators on the pager will show this code.
To set a different station number:
1. Press SETUP and enter Password.
2. Press 1) System.
3. Press F2 (DN) until the display shows 3) Station ID.
5. Press 3 (3: Station ID).
6. The display shows the current station ID number (default is 1).
7. Press a number to use (0 – 9) to change the default Station ID number and press ENTER.
Adjust Transmit Power
The range may be increased or decreased from the transmitter by adjusting the transmit power level. The
!
Long Range Systems
23
Freedom User Manual
