10
Position the transducer so its face is pointing straight down when the trolling
3.
motor is in the water.
Tighten the adjustable strap
4.
securely to the trolling motor.
Make sure there is enough slack
in the transducer cable for the
trolling motor to turn freely.
Mounting display unit
Before mounting the display unit mount, make sure there is nothing in the area that will obstruct
the display unit when it is installed on the bracket.
To install bracket mount:
Place the bracket on the desired mounting surface and mark the four mount-
1.
ing holes. If you want to run the unit’s cables up through the mounting surface,
make a mark in the center of the bracket mounting surface.
Drill pilot holes for the four mounting holes. If desired, use a 1-inch (25mm) bit
2.
to drill the center cabling hole in the mounting surface.
The top of the Pod
transducer is curved to fit
the contour of the trolling
motor, so you do not
need a TMB-S mounting
bracket.
Installation
