Lowell UPS9 Series Manual
Pg. 12
UPS Input Connection.
Connect the UPS to an approved electrical input source consistent with the input power cord connection provided with the
UPS . Do not replace the power cord or use a substitute . Avoid using extension cords when connecting AC input to any UPS .
UPS Output.
There are two types of output on the UPS9-1000, UPS9-1500, UPS9-2000, and UPS9-3000 models — programmable outlets
and general outlets . Connect non-critical devices to the programmable outlets and critical devices to the general outlets . During
power failure, you may extend the backup time to critical devices by setting shorter backup time for non-critical devices .
Programmable outlets can also be used to re-cycle the power to remote devices if required to re-start a server due to lock-up
issues .
Starting the UPS
Press the ON/MUTE button on the front panel of the UPS for two seconds to power on the UPS .
Note:
The battery charges during the first five hours of normal operation . Do not expect full battery run time during the initial
charge period .
Software Installation
For optimal system protection, install UPS monitoring software to fully configure UPS shutdown . Follow steps below to down-
load and install monitoring software, or simply install via the included CD:
1 . Go to the website http://www .power-software-download .com
2 . Click ViewPower software icon and then choose your required Operating System to download the software .
3 . Follow the on-screen instructions to install the software .
4 . When your computer restarts, the monitoring software will appear as an orange plug icon located in the system tray near the
clock .
Step 2:
Carefully lower the UPS into the brackets as shown .
Step 3:
The UPS is now mounted as shown in the tower position .
