background image

ACSP2004-IG-GTF

20A Single-circuit Surge Suppressor with Ground Transient Filter

Lowell Manufacturing Company

• 100 Integram Drive • Pacific, Missouri 63069 U.S.A.

Call

800.325.9660, 636.257.3400 • 

Fax

636.257.6606 • 

Click

www.lowellmfg.com

Lowell makes every effort to provide accurate information and reserves the right to change specifications and/or improve manufacturing methods. 
Download and print this spec from www.lowellmfg.com to insure that you have the most current information

1c-107

pg 4 of 4

ACSP2004-IG-GTF wiring using only factory-installed receptacle

ACSP2004-IG-GTF wiring using factory-installed rece aux. receptacle

ACSP2004-IG-GTF wiring for permanent (hardwire) installation (no receptacles)

ACSP2004-IG-GTF wiring using only factory-installed IG receptacle

ACSP2004-IG-GTF wiring using factory-installed IG rece aux IG receptacle

ACSP2004-IG-GTF wiring for permanent (hardwire) installation (no receptacles)

Factory installed
duplex receptacle

1) Connect input (line)

to pigtails. 

Any knock-

out may be utilized.

2) Install blank cover.

1) Cut leads to factory

installed
receptacle. Splice
in leads from 
auxiliary receptacle.

Alternate Method: Remove receptacle from plate. Connect auxiliary receptacle leads to

screw terminals. Re-install receptacle to plate.

Safety Ground (see *Note)

Neutral (white)

Line (black)

Typical Wiring ACSP2004IG-GTF 

(with safety ground only)

Auxiliary

Receptacle

(shown connected)

2) Cut or disconnect

wires to factory
installed receptacle.

4) Connect load

(output). Any
knockout may
be utilized.

5) Connect Green

wire from board
to isolated
ground.

6) Install blank

cover on each
side.

Factory installed
isolated-ground
duplex receptacle

Alternate Method: Remove receptacle from plate. Connect auxiliary receptacle leads to

screw terminals. Re-install receptacle to plate.

3) Connect safety

ground (green) 
from load side.

4) Connect load

(output). Any
knockout may
be utilized.

4) Connect Green

wire from board
to isolated
ground.

6) Install blank

cover on each
side.

Typical Wiring ACSP2004IG-GTF 

(with independent isolated ground)

Ground Stud

2) Cut or disconnect

wires to factory
installed receptacle.

1) Connect input (line)

to pigtails. 

Any knock-

out may be utilized.

2) Install blank cover.

1) Cut leads to factory

installed
receptacle. Splice
in leads from 
auxiliary receptacle.

Safety Ground (green)

Neutral (white)

Line (black)

Isolated Ground 

(green/yellow stripe)

Auxiliary

Receptacle

(shown connected)

1) Connect input (line)

to pigtails. 

Any knock-

out may be utilized.

Safety Ground (see *Note)

Neutral (white)

Line (black)

1) Connect input (line)

to pigtails. 

Any knock-

out may be utilized.

Safety Ground (green)

Neutral (white)

Line (black)

Isolated Ground 

(green/yellow stripe)

*Note: Connect bonding
jumper and green striped
wire from GTF.

*Note: Connect bonding
jumper and green striped
wire from GTF.

3) Connect safety

ground from load
side.

Отзывы: