CPLC-100
Page
9
Installation
Using Conveyor Side Bracketry or Floor Stand to mount the controller
unit.
NOTE: It is highly recommended that a power line conditioner /
regulator be used with the VersaJet LC (see Optional Spare Parts
P/N CPVA40-003-0).
Connect the detachable power cord of the transformer to the connector
located under the ON/OFF switch on the bottom of the unit.
Locate the following parts for the printhead.
•
Mounting block assembly with Hand Knob.
• L-Bracket
with
Thumbscrews and
Clamping Nut.
Secure Mounting Block Assembly with opening
vertical to the support structure that will hold the VersaJet.
Use the four bolts supplied to secure the block to the
structure.
Insert the L-Bracket through the Mounting Block and
tighten the Hand Knob.
Loosen Thumbscrews on the top of the L-Bracket.
Slide the Clamping Nut into the VersaJet LC
Mounting Channel (running the length of the unit on the
bottom).
Plug printhead into the controller.