11
Operating Instructions for
LTS 138 / 150 SAC
A
ll data is without guarantee, errors and changes are reserved
.
LOTUS TRANSFER PRESS SOLUTIONS GmbH & Co. KG
9.
Directions for Use
Please note the risks involved in using a transfer press mentioned in paragraph 4 of
this manual, in particular
•
the risk of squashing your hands in between the plates
•
the risk of an electric shock
•
the risk of burning your hands and arms on the heating plates
Wear protective gloves to avoid the risk of getting burned.
Switch on the transfer press by setting the ON/OFF switch to
I
. In ON position a pilot lamp
will glow. Now the desired operation parameters can be set.
1) Plug the connector cable into a power socket of 220 V.
2) Set the main switch from 0 to 1.
3) Set the desired temperature.
4) Set the desired pressing time on the timer.
5) Find out the necessary printing pressure by trial printing.
6) To adjust the pressure, turn the pressure controller
-
clockwise to reduce the pressure
-
anti-clockwise to increase the pressure
ATTENTION: CHANGE THE PRESSURE ONLY WITH THE PLATES OPEN
7) Put the textile to be printed on the supporting plate and place the desired transfer onto
it.
8) To start the transfer process, pull down the lever. This will cause the press to close
and the heating plate will be pressed onto the supporting plate. The transfer process is
running now. After the set time has elapsed, heating plate will now be lifted automati-
cally.
The press is now ready for a new transfer process.
Operating Parameters
Please set the operating parameters (time and temperature) by using the display and the
LEDs on the control panel.