LORTONE, inc • 12130 Cyrus Way, Mukilteo, WA 98275 • Phone: 425-493-1600
3/08
Page 3
Copyright © 2008 Lortone, Inc
Polishing Head Installation
The LU6X-130 machine comes with a felt-faced polish head. Insert
the ¼-20 threaded end of the polish head into the end of the shaft
and tighten by turning the polish head clockwise. Avoid contaminating
the polish head during installation.
For versatility, additional polish heads can be purchased either with or
without the felt. Leather discs can be attached to the rubber face
polish-heads with feathering disc cement. If these heads are used for
sanding and are threaded 1/2” N.F.R.H., they may be installed on shaft
as show in Fig. 5. If they are used with a polishing pad, it is
recommended they be installed on the shaft by themselves (see Fig. 6)
to eliminate possibility of contamination.
Sawing
Pour coolant into saw case until 1/4” of blade is emerged in coolant
(see Fig. 7). We recommend using water with a rust preventative or
quality oil formulated for lapidary use.
CAUTION: DO NOT use
Kerosene, Motor Oil, Transformer Oil, or Automobile Antifreeze
.
Feed material into the blade with even pressure. Never force the
material into the diamond blade. The rate of feed should never be so
great that the blade slows down. For difficult to handle shapes, clamp
the material in the vise.
Grinding
It is important to remember that the saw is still running while the LU6X
is being used for grinding, sanding or polishing. To reduce coolant mist
from the saw when using the grinding side of the machine, place a
small household sponge on the trim table directly in front of the blade.
When you are ready to use the saw, remove the sponge.
The LU6X is designed to be operated with either a water drip system or
a recalculating system.
Water
Grinding Wheel
Sponge
Polishing Head
Shaft
Fig. 7
Fig. 6
Make sure 1/4” of
blade is submerged
in coolant
Shaft
Collars
Polishing
Head
Sanding
Drum
Spacer
Fig. 5
Periodic Maintenance
The bearings used in this arbor are sealed and lubricated for life. The nuts and collars are plated to
resist corrosion. The shaft is stainless steel which will also resist corrosion.
Helpful Hints
If it is inconvenient to hook up water valve and drain on grinding wheel side of unit, an acceptable
option can be to place a small amount of water in pan and carry it to the grinding wheel with the use
of a house hold sponge (see Fig.8).
The LU6X-130 is supplied with a 2-1/2” pulley & V-belt. A precision turned, ground, and polished shaft
is mated with sealed for life ball bearings for smooth, quiet operation. The point to remember is that
the basic machine is a smooth running unit. Vibrations and noise, which can occur during operation
of your machine, can often be traced back to the items being installed on the arbor shaft (grinding
wheels, sanding drums, polishing heads, etc.) not being trued and balanced.
