2
1 INTRODUCTION .......................................................... 2
2 WARNINGS ................................................................. 3
3 DIMENSIONS .............................................................. 3
4 SYSTEM REPORT FORM ............................................ 4
5 INSTALLATION CONTROLLER PS150 ....................... 5
5.1 General Information ................................................ 5
5.2 Warnings to Installer ............................................... 5
5. 3 Mechanical Installation ........................................... 5
5.2 Technical Data ......................................................... 5
5.4 Electrical Installation-Terminals ............................. 6
5.5 Monitoring ................................................................ 6
5.6 Wiring Order for Correct Rotation ............................ 7
7 System Wiring ........................................................... 8
7.1 System Wiring for 12 V Battery Installation ............. 8
7.2 System Wiring for 24 V Battery Installation ............. 8
7.3 System Wiring for 12-24 V Solar Direct Operation .. 9
7.4 Battery High Run Jumper..............................................9
7.5 Power Control for Solar Direct Operation ............... 9
8 TROUBLESHOOTING ................................................ 10
9 WARRANTY ............................................................... 10
CAUTION
recommended to avoid disfunc-
tion or premature ageing of the
pump etc.
WARNING
disregard might lead to injury or
damage the installation
Symbols
Thank you for purchasing a LORENTZ PUMP.
We
set
a new standard for quality and economy in solar
pumping. It incorporates the best solar pump technolo-
gies that were very expensive until its introduction in
2002.
1 INTRODUCTION
PS150 is a highly efficient pump system
which
provides city water pressure, anywhere. It is
economical for (drip-) irrigation, livestock, dugout
floating pump, water transfer to remote places and
many other applications. It is a submersible pump.
The pump end of PS150 is a
positive displacement
type pump or a centrifugal
one.
The PS150
brushless DC motors
are specially made
for this system. The motor is using very advanced raw
earth magnet technology, hand made wiring for highest
copper density and does not need wearing brushes.
This results in an exceptional high efficiency with low
temperature dissipation.
PS150 can either be used in a
battery system
with
voltages of 12, 24V or alternatively it can be operated
as a
solar direct system
using the same Controller
PS150.
The solar battery is charged up during daylight hours
using the integrated charger of the PS150 controller.
The charger works effectively during reduced sunlight
conditions when direct pump operation is not possible.
The energy stored in the battery is available to operate
the pump at any time, day or night and during periods
of bad weather.
Extended bad weather periods with water demands of
up to 10m
3
per day will be reliably bridged due to the
high system efficiency even with low capacity batteries.
The pump is
manufactured from non-corrosive
material
(stainless steel).
Before you begin
Check the model
numbers of all the components of your
system, and verify that they are the items
that you ordered. Also check against the
PUMP
specifications and performance
charts (end of this manual) to be sure the
system is appropriate for your application. If you think
you may have the wrong pump for your application, call
your supplier immediately.
Please fill in the SYSTEM REPORT
. This will be essen-
tial information if any problems occur.
CONTENTS
