TABLE OF CONTENTS
E 7
MEASURE:
Choice of monitored measure.
VOLTAGE?
Push the
YES
button to choose the displayed type. Push the
NO
button to display the
next measurement type.
MEASURE 0%?
Push the
YES
button to access the measure low scale setting.
MEASURE 100%?
Push the
YES
button to access the measure high scale setting.
HOLD TIME?
Peak voltage hold time setting access (0.01 s to 60 s). This menu is only visible if the user
has chosen the monitoring of the PEAK VOLTAGE measure.
OUTPUT 2?
Push the
YES
button to access to the output 2 configuration (only with /S2 option).
Same as output 1 except peak voltage measure choice is not present.
The default factory parameters are:
For output 1: output scale = 4/20 mA, input scale = 0/600 V, response time = 0 s, no limitation.
For output 2: output scale = 4/20 mA, input scale = 0/5 A (standard) or 0/2000 A (Rogo) or 0/100 Adc (Hall)
response time = 0 s, no limitation. See
page 11
for more details about the output parameters.
4.6) Display configuration
This section allows you to customize the display of measurements on front.
DISPLAY CONFIG?
Push the
YES
button to access to the rubric.
DISPLAY FILTER?
Push the
YES
button to access the display filter setting (0 to 60 s).
Allows filtering of the displayed value to smooth fluctuations of the measurement.
DECIMAL POINT?
Push the
YES
button to access the decimal point mode setting.
AUTO(Y/N)?
Pressing
YES
selects the automatic decimal point display mode.
Pressing
NO
selects the fixed mode.
NUMBER OF DECIMAL FOR: Choosing the number of decimals (0, 1 or 2) for each measure in fixed mode.
VOLTAGE?
Push the
YES
button to access the number of decimals displayed for the voltage measure.
CURRENT?
And so on for all the other measurements.
FREQUENCY?
ACTIVE P.?
REACTIVE P.?
APPARENT P.?
POWER FACTOR?
4.7) End of configuration
OK!
This message indicates that all the parameters have been successfully saved.
Remark:
If, during the configuration process, no buttons are pressed for more than 90 s, the device returns to measure mode
without saving the new configured parameters.
