Lopi Yankee, Руководство пользователя

Страница: 21 / 40

Operation
1 9
Travis Industries 9 3 5 0 8 1 0 8 0 4 0 1 9 9
Loading Pellets
Lift the hopper lid to its vertical position. Pour pellets into the hopper until full. NOTE: The hopper
holds approximately 80 pounds of pellets.
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
AAAAAAAAA
AAAAAAA
AAAAAAA
AAAAAAA
AAAAAA
AAAAAA
AAAAAA
AAAAA
AAAAA
AAAAA
AAAAA
AAAAA AA
Make sure pellets
are not left on this
heat shield.
Pe
t
e l
s
l
To Close the Hopper Lid:
lift the lid, pull this bar forward,
then lower the lid down.
To Open the Hopper Lid:
lift the hopper lid from this
handle.
Warning:
The front edge of the
hopper lid becomes very
hot, do not touch the area
below the handle.
These notches allow
you to open the hopper
lid to the level you wish.
The Two Modes of Operation:
M a n u a l
Manual mode requires the user to turn
the heater on and off manually.
Auto (requires a thermostat)
Auto mode allows you to use a
thermostat to control room
temperature. The stove automatically
turns on when the temperature drops
below the thermostat setting. Once the
stove reaches operating temperature,
the stove then runs at the heat output
setting selected.
Switching Modes While in
Operation
Whenever the stove is switched from
one mode to another while in
operation, the stove will enter the "start-
up" sequence for a minimum of 10
minutes.
H
E
A
T
O
U
T
P
U
T
HIGH
MED
LOW
AUTO
MANUAL
AUGER
ON
HEAT OUTPUT
AUTO
OFF
MANUAL
A
A
MANUAL
START
FAULT
W
O
L
H
E D
M
I
G
H
W
O
L
H
E D
M
I
G
H
FAN
Use the
mode switch
to determine
the mode.
These
indicator
lights are
used to
determine
which mode
you are in.