Lonking CDM307, Руководство по эксплуатации

Страница: 25 / 81

CHAPTER
Ⅰ
SAFETY INFORMATION
19
Note: The three-point contact can be both hands and a foot or both feet and a hand.
1.5.14.3 Do not mount the moving machine. Prohibit getting down from the moving machine. Do
not jump down from the machine. When get up and down machine, do not carry tools or objects. Use
hand-pulled rope to pull the equipment to the platform. Do not use the lever as handrail, when into and
out of the cab.
1.5.15 BEFORE OPERATION
1.5.15.1 Make sure that there are no personnel in the area around the machine.
1.5.15.2 Clear all obstacles on the path of the machine. Beware of hazards, such as wires, ditches
and so on.
1.5.15.3 Make sure that all windows are clean. Secure the doors and the windows in the open
position or in the closed position.
1.5.15.4 Adjust the rear view mirrors for the best vision of the area around the machine.
1.5.15.5 Ensure that the horn, the backup alarm, and all other warning devices are working
properly.
1.5.16 OPERATION
1.5.16.1 Only operate the machine while you are sitting in a seat. the seat belt must be fastened
while you operate the machine. only operate the controls while the engine is running.
1.5.16.2 When you operate the machine and work tools slowly in an open area, check for proper
operation of all controls and all protective devices.
1.5.16.3 Before you move the machine, make sure that no one will be endangered.
1.5.16.4 Do not allow riders on the machine unless the machine has an additional seat with seat
belt.
1.5.16.5 Note any needed repairs during machine operation. Report any needed repairs.
1.5.16.6 Do not go close to the edge of a cliff, an excavation or an overhang.
1.5.16.7 Avoid operating the machine across the slope. when possible ,operate the machine up
the slopes and down the slopes.If the machine begins to sideslip on a downgrade, immediately remove
the load and turnthe machine downhill.
1.5.16.8 Avoid any conditions that can lead to tipping the machine. the machine may tip when
you work on banks and on slopes. also, the machine may tip when you cross ditches, ridges or other
unexpected obstacles.
1.5.16.9 Maintain the control of the machine. Do not overload the machine beyond the machine
capacity.
1.5.16.10 Make sure that hooks and dragging are enough. Traction device can only be connected
to the traction pin or hook. Never allow other personnel to straddle a wire cables.