Lonking CDM307, Руководство по эксплуатации

Страница: 23 / 81

CHAPTER
Ⅰ
SAFETY INFORMATION
17
machine, do not allow any flammable material to accumulate on the surface of the machine.
1.5.9.4 Do not operate the machine near any flame.
1.5.9.5 Do not weld or flame cut on tanks or lines that contain flammable fluids or flammable
materials. Clean the lines and tanks with a nonflammable solvent prior to welding or flame cutting.
1.5.9.6 Check all the wires before starting the machine every day. Repair loose or frayed wires,
clean and tighten all the line connectors before operation.
1.5.9.7 Inspect all lines and hoses for wear or deterioration. Replace damaged lines and hoses in
time . Damage to the protective cover or insulation may provide fuel for fires. Make sure the lines and the
hoses should have adequate support and secure clamps.
1.5.9.8 Be careful when you are filling fuel , lubricants and other oil to a machine. Do not smoke
while you are filling fuel , lubricants and other oil to a machine. Do not fill a machine near open flames
or sparks. Always stop the machine before filling oil. fill the fuel tank outdoors.
1.5.9.9 Gases from a battery can explode. Keep any open flames or sparks away from the top of a
battery. Do not smoke in battery charging areas.
1.5.9.10 Do not jump a metal object to the terminals of the wires to check the battery charging
condition. Do use a voltmeter or hydrometer .
1.5.9.11 Incorrect jumper cable connections can cause an explosion that may result in personal
injury. Please refer to " maintenance and cautions of suitable battery for the loader " for specific
instructions.
1.5.10 LINES
1.5.10.1 Do not bend high pressure lines. Do not strike high-pressure lines. Do not install any lines
that are bent or damaged .
1.5.10.2 Please repair any lines that are loosen or damaged. Leaks may provide fuel for fires.
Consult your Lonking dealer for repair or for replacement parts.
1.5.10.3 Perform a double check to lines. Do not use bare hands to check for leak. Please Use
board or cardboard to check for leak.
1.5.10.4 If any one of the following conditions is present , replace the parts:
1
．
End joint damaged or leaking
2
．
Outer coverings are worn or cut
3
．
Wires are exposed
4
．
outer covering are swelling or ballooning
5
．
flexible parts of the hoses are kinked.
6
．
end fittings ara displaced
1.5.10.5 Make sure that all clamps, guards, and shields are installed correctly. During machine
opertion, this will help to prevent vibration,rubbing against other parts, excessive heat .