Specification
17
2011/01/07
Version:
2.2
2.2d 2-in-1 Card Reader Installation……
An optional 2-in-1 Card Reader can be installed on the right side of GFT-150 Terminal.
A 2-in-1 Card Reader
A metal piece for securing 2-in-1 Card Reader
A cable clip
Screw x 4
Installing a 2-in-1 Card Reader
Note:
Before installing a 2-in-1 Card Reader, please make sure the jumper is set correctly on the
main board (Please refer to 2.2a COM power selection). The supply voltage for the 2-in-1 Card
Reader should be set to +5V.
1.
Turn off the system power.
2.
Using two screws to secure the 2-in-1 Card Reader to the metal plate.
3.
Using two screws to secure the 2-in-1 Card Reader to the right side of the monitor.
4.
Loosen the two screws on both sides as the picture shown below.
