Safety
- 5 -
separate welding space must be applied for. Please refer to relevant
regulations of China and other countries.
z
Use internal inspection and test means to ensure the working environment is
clean and orderly.
10) Safety measures to guarantee normal work of welding/generating
set
z
Before running the set, check whether all safety protection requirements are
met.
z
Don’t touch any hot part of the set within 30 minutes after the set is shut down,
so as to ensure no personal injury will occur when you start the workstation.
z
Inspect the set at least once a week, conduct a check of the set’s external
surface for any damage, and test its safety performance.
11) Safety inspection and test
z
All operations about the set’s modification, installation of accessories,
maintenance and repair of parts and components, regular maintenance, overall
inspection and test (which must be performed once for every period not
exceeding 6 months), etc. shall be assigned by the owner/ keeper of the set to
electric experts.
12) Modification of welding/generating set
z
It is better not to make any modification to the set, to install any accessory to it,
or to change any preset parameter of it without the manufacturer’s permission.
z
Defective parts or components must be replaced timely.
13) Spare parts and wearing parts
z
Only the spare parts and wearing parts supplied by the manufacturer of the set
may be used, because it cannot be ensured that the parts from other suppliers
can meet the special design requirements and other requirements relating to
voltage endurance and safety of this set.
z
Before purchasing spare parts, please mark the specific names of the parts and
relevant part numbers, and give relevant descriptions in the list of the spare
parts.
Содержание WG6500M-1
Страница 1: ......
Страница 4: ......
Страница 29: ...Schematic diagram 25 X Schematic diagram ...
Страница 31: ......
