LOKERMANN Grand Tig 200, Руководство пользователя

Страница: 27 / 32

Remote Control
Socket
Socket Pin Function
1 Be shorted with 2
2 Be shorted with 1
3 20k ohm (maximum) connection to 20k ohm remote control potentiometer
4 Wiper arm connection to 20k ohm remote control potentiometer
5 Zero ohm (minimum) connection to 20k ohm remote control potentiometer
6 Not connected
7 Not connected
8 Trigger Switch Input
9 Trigger Switch Input
10 Not connected
11 Not connected
12 Not connected
3.6
Operation
environment ▲ Height above sea level ≤1000 M
▲ Operation temperature range -10
〜 +40°C
▲ Air relative humidity is below 90 %( 20°C)
▲ Preferable site the machine some angles above the floor level, the maximum
angle does not exceed 15 ℃ .
▲ Protect the machine against heavy rain AND against direct sunshine.
▲ The content of dust, acid, corrosive gas in the surrounding air or substance
cannot exceed normal standard.
▲ Take care that there is sufficient ventilation during welding. There must be at
least 30cm free distance between the machine and wall.
3.7
Operation
Notices
▲ Read Section §1 carefully before starting to use this equipment.
▲ Connect the ground wire with the machine directly.
▲ Ensure that the input is single-phase: 50/60Hz, 110V/220V ±10%.
▲ Before operation, none concerned people should not be around the working
area and especially children. Do not watch the arc in unprotected eyes.
▲ Ensure good ventilation of the machine to improve Duty Cycle.
▲ Turn off the engine when the operation finished for energy consumption
efficiency.
▲ When power switch shuts off protectively because of failure. Don’t restart it until
problem is resolved. Otherwise, the range of problem will be extended.
▲ In case of problems, contact your local dealer if no authorized maintenance
staff is available.