4.3
Welding
operation
(1) Place the Wire Spool onto the Spool Holder. Snip the wire from the spool being sure to hold the
wire to prevent rapid uncoiling. Feed the wire into the wire feeder inlet guide tube through to the
drive roller.
(2) Carefully feed the wire over the drive roller into the outlet guide tube, feed through about 150mm
into the torch receptacle. Check that the drive roller size is compatible with the wire diameter,
replace the roller if necessary.
(3) Align the wire into the groove of the drive roller and close down the top roller making sure the wire
is in the groove of the bottom drive roller, lock the pressure arm into place. Apply a medium
amount of pressure to the drive roller.
(4) Remove the gas nozzle and contact tip from the torch neck.
(5) Press and hold the manual wire button to feed the wire through to the torch neck, release the
manual wire key when the wire exits the torch neck.
(6) Fit the correct sized contact tip and feed the wire through it, screw the contact tip into the tip
holder of the torch head and nip it up tightly.
(7) Fit the gas nozzle to the torch head.
(8) Carefully open the gas cylinder valve and set the required gas flow rate.
(9) Select 2T/4T trigger function.
(10) Set the required welding parameters to suit the material thickness being welded, it will show on
the digital meter .
(4) Remove ghe gas nozzle and contact
tip front the front and the mig torch.
(8) Carefully open the gas cylinder valve
and set the required gas flow rate.
(5) Press and hold the manual wire switch
(right) to feed the wive down the torch cable
trought to the torch head.
(3) Close down the top rolleer bracket and clip the
pressure arm into place with a medium amount of
pressure applied.
(6) Fit carrect size contact tip over the wire and
fasten tightly into the tip holder.
(7) Fit gas nozzle to the torch head.
(10) Select the required welding parameters
using the knobs.
(9) Select toch switch 2T/4.
(2) Feed wire over the drive roller into the
outlet guide tube, Plus the wive trought
approx 150mm
(1)Place wire onto spool holder-(spool
spool retaining nut is left hand thread ) Feed the
wire through the inlet guide tube on to the drive
roller
