24
Risk of serious injury.
Never connect the machine if the chip outlet is
open. Either the cover plate (B 11) or the chip chute
(B 17) with hose secured with a hose clamp, must
be fitted.
Maskinen kan användas utan spånfläkt även om det
inte är att rekommendera då det blir mycket spån.
You should use an effective chip extractor with a
capacity of at least 500 m
3
/h. 1.5 kW is sufficient in
most cases.
Build a chip pocket, or blow the wood debris directly
into a trailer or the like. Bear in mind that there has
to be an air outlet in your chip container (e.g. a fine-
meshed net, or a filter if you collect the wood debris
indoors). Poor extraction capacity is often due to a
too limited air flow out of the chip container. Build
a chip pocket, or blow the wood debris directly into
a trailer or the like. Bear in mind that there has to
be an air outlet in your chip container (e.g. a fine-
meshed net, or a filter if you collect the wood debris
indoors). Poor extraction capacity is often due to a
too limited air flow out of the chip container.
If you use the machine in a heated room, the chip
extractor will soon cool the room if you do not direct
the air back into the facility.
Dust emission and risk of fire have to be taken into
consideration when collecting wood debris.
Connect the chip hose, and fasten it with hose
clamps both on the log moulder and the chip
extractor. Use the Flexi Hose from Logosol (length:
3 m (10 ft), ref. no. 7000-000-1015) which has a
smooth inside improving the flow.
If you want to convey the wood debris a long way:
Place the chip extractor close to the machine, so
that you can use as short hose as possible. Then
convey the wood debris in a sheet metal pipe, which
reduces resistance for the air flow.
Risk of fire and dust emission when collecting
wood debris.
Consult your local authorities about the
regulations in your district.
Place the chip extractor so that its power switch is
easily accessible.
Wire kit
10 metres (33 ft) of wire, rollers and turnbuckles for
suspension of chip hose and power cable.
Ref. no. 9999P000P9999
Chip chute
Compatible with the Log House Moulder LM410.
D 100 mm (4’’).
Ref. no. 9999P000P9999
Chip hose
The wood debris should be conveyed in sheet metal
pipes. This is cheaper and gives less resistance for
the air flow and the wood debris. However, closest
to the sawmill and the log moulder you have to use
a flexible chip hose. If you are going to suspend the
hose on a wire from the ceiling, you should add 2 m
(6 ft) to the hose length. Flexi hose, D 100 mm.
Ref. no. 9999-000-9999
Chip Extractor
Logosol has a wide range of suitable chip extractors.
Consult our customer service to get the right
equipment.
CHIP MANAGEMENT
