Logosol KS150, Руководство пользователя

Страница: 14 / 20

14
The Control Panel
1. Main Power Switch
2. YD-Start / Stop of the Saw Blade.
To start the saw blade, you set the control
switch on ”Y” and wait until the motor is
at full rev. Then you set the control switch
on ”D”, which is symbolized by a triangle
(delta).
3. Start / Stop of the Feeding.
The feeding can only be started when the
saw motor is running.
4. Emergency Stop Button
After an emergency stop you reset the
emergency stop button by turning it. The
safety edge at the in-feed opening has
the same function, but it does not require
resetting after having been activated.
The feeding will be damaged if the knob
for adjusting feeding speed is turned
when the feeding is not running.
The feeding speed may only
be adjusted when the feeding
is running. The speed ranges
from 4 to 12 m/minute (13-
39 ft/min.). Lower speed
gives a finer cut surface. The
speed increases when the knob is turned
clockwise, and decreases when the knob
is turned anticlockwise.
Adjust the feeding pressure by pushing in
the feed roller so that the distance between
the feed roller and the fence is approx. 20-30
mm (0.8-1”) less than the width of the work
piece. Damp work pieces require higher
feeding pressure.
If the feeding is skidding against the work
piece, the reason can be that the in- and
out-feed tables are set incorrectly. Make
sure that the in- and out-feed tables are
set at the correct hight, that they are in line
with the machine table, and that the rollers
are slightly above the machine table (see
Adjusting the Tables and Rollers ).
Adjusting the Feeding
Checking the Safety Functions:
1. Start the saw blade and the feeding.
Press the red emergency stop button on
the control panel. The machine should now
stop.
2. Start the saw blade and the feeding.
Press the safety edge on the upper side of
the in-feed opening in the machine cover.
The machine should now stop.
If any of these functions do not work the
machine may not be taken into use.