Logosol B1001, Руководство пользователя

Страница: 63 / 64

63
PROBLEM/SYMPTOM PROBABLE CAUSE ACTION
Nothing happens when you activate the levers Low oil level in the tank
Fuse has tripped
Incorrect hose connection on the valve
Pump motor runs in the wrong direction (Phase-
inverted motor) Check the oil level and refill if necessary
Check fuses in fuse cabinets
Check connection has been executed as in the
manual.
Phase-inverted motor in the coupling.
The pump does not start when the power is
turned on Fuses have tripped
Connectors not put together properly Check fuses
check connectors
Oil leaking from the machine Check whether leaking coupling is tightened
Check hoses for leaks Re-tighten loose couplings
Replace damaged hoses
One or more functions are perceived to be
under-powered. Low oil level in the tank
Leakage in the system
Air in the system
Damaged hydraulic cylinder Check the oil level in the tank
Re-tighten loose couplings
Replace damaged hoses
Run the functions one by one until the air is forced
out of the system to the tank
Run the piston rod out into its end position, turn
off the machine. If there is a lot of play in the
piston, the gasket and piston control may be
broken.
Functions move jerkily Low oil level in the tank
Leakage in the system
Air in the system Check the oil level in the tank
Re-tighten loose couplings
Replace damaged hoses
Run the functions one by one until the air is forced
out of the system to the tank
Sawn blocks are not perpendicular Log supports not aligned
Sawmill not aligned Adjust the log supports perpendicular to the saw
bed
Check against alignment sequence in the sawmill
manual
TROUBLESHOOTING SCHEDULE
HYDRAULIC DIAGRAM