Logosol B1001, Руководство пользователя

Страница: 46 / 64

46
4 x – M2
2x – M12x90
2x – M12x25
4 x – M12
4 x – M12
78,5mm
The hydraulic hoses shall be secured on their route up
to the operating position. Using the brackets supplied,
be sure to collect the hoses in a neat bundle and also
ensure that they are not pinched so that the brackets
cause wear to the hoses. When the hose brackets are
mounted, proceed to assemble the floor above the
hydraulic unit.
Operating position
The angle of the log supports is adjustable. The goal is
to achieve a 90 degree angular ratio in relation to the
log bed. Undo the screws that hold the log supports in
the bed. Note that the upper screw towards the centre
of the rail should only be very slightly loosened. Then
use the knob to adjust the angle. When the angular
ratio is 90 degrees, tighten the fastening screws and the
knob.
Adjusting log support
Adjusting log bed
If, after installation, the log supports are at different heights
in relation to each other, the log beds must be adjusted. It is
the length of the linkage that determines the height of the log
supports. To adjust, undo the log beds’ screw joints and adjust the
beds in the oblong grooves so that the log supports end up at the
same level. Then re-tighten the screw joints.