P a g e
|
37
Logmar Camera Solutions IVS
When loaded correctly (like the
photo on the left) there should be
absolutely no light penetrating
between the pressure plate and the
film as it can be seen on this photo
You might need to pull the film
downwards in order to see clearly
into the gate if light is leaking or not.
20.
Turn the camera on
(without putting the lid on yet)
21
.
Invoke “Load film cassette” in the menu
22.
Set the frame rate to 18ps and run the camera for a few seconds while observing that the
Latham loop remains intact.
22.
Turn the camera off
(for safety)
and run your fingers along the film perforations. Feel if there is
any burrs or dents in the perforations if that is the case or if the film does not feel completely
smooth, you have not loaded the camera correctly.
Make sure to feel the perforations on both sides of the
film and run your fingers along the film – this makes it
easier to determine if the loading was correct or not.
If the film is not loaded correctly, the camera can
punch new perforations or tear the film so be sure to
check it toughly.
