logitrans LOGIFLEX SELFR 1001/1600, Руководство пользователя

Страница: 13 / 32

13
A
3.6 Adjusting of stop
The forks are factory-set to stop in 45º. If another setting is required, the Rotator
can be set electronically to stop in different angles.
1) The forks are placed in horizontal position
2) Short pressure on the switch A activates the
setting procedure. The controller gives a signal
(one beep)
3) The forks are placed in the requested angle
4) When the forks have reached the requested angle,
the controller will give signal after three seconds
(one beep), when the position has been stored.
The procedure is repeated to set stop in the opposite
side.
3.7 Setting the speed
1) The forks are placed in horizontal position
2) The switch is pressed three seconds, and two short
beeps will be given. The switch is released and
the speed is set by activating the remote control.
Clockwise: Increasing the speed
Counter-clockwise: Reducing the speed
Note: Maximum tilt speed: 360º/minute.
3) When the requested speed has been reached, the controller will give signal
after three seconds (two beeps), when the position has been stored.
3.8 Reset the settings
1) The forks are placed in horizontal position.
2) Press switch A, until five beeps are given. The switch is released and
the controller is set to maximum speed and stops at 45°.
Plug from
remote control
Switch A
Signal
3.0 How to operate the Rotator