13
14
ON
LEVEL MIN
MAX
9
10
11
12
8
7
12
15
18
16
19
20
22
23
24
13
14
17
21
LifeSize® Unity 1000™
with LifeSize® Express 220™
12
Use the camera screw to secure the camera to the top of the camera
shelf.
13
Use 2 thumbnuts to secure the camera shelf to the back of the display.
14
Connect one end of the camera’s DC power cable and HD cable (from
cable bag 3) to the back of the camera, and thread the other ends
through the slot at the top of the stand.
15
Connect the free ends of the camera’s DC power cable and HD cable
to the electronics box and video system, respectively, indicated by cables
7-8 on the wiring diagram.
16
Remove the cables from bag 4 and connect them from the video
system to the appropriate component, indicated by cables 9-12 on the
wiring diagram.
17
Use 6 thumbscrews to mount both speakers horizontally to the sides
of the stand, immediately below the HD display.
18
Facing the back of each speaker, thread the speaker’s AC power cable
and audio cable (from cable bag 5) under the mounting bracket and
connect them to the back of the speaker.
19
Connect the free ends of the speaker’s AC power cable and audio
cable to the electronics box and video system, indicated by cables 13-14
on the wiring diagram.
20
Place the back cover against the back of the stand and press it toward
the stand until it snaps into place.
21
Connect one end of the network cable (from bag 6) and system AC
power cable to the wall and the other end to the back of the electronics
box, which is exposed through the hole in the lower back of the stand.
Refer to cables 15-16 on the wiring diagram.
22
Turn on power and wait for the system to initialize. The System
Con
fi
guration screen appears after approximately two minutes, at which
point you can use the remote to con
fi
gure the system. Refer to the
LifeSize Video Communications Systems User and Administrator Guide
for
instructions.
23
Tuck loose cables inside the stand. Place the front cover against the
front of the stand and press it toward the stand until it snaps into place.
24
Position the speaker cover over both speakers and gently press
forward until it snaps into place.
