Logitech KeyCase, Руководство по установке

Страница: 3 / 16

English
3
5. Reset the Palm
™
handheld by tapping the Reset button. After resetting, if you have another keyboard driver installed
on your Palm
™
handheld, or any other software that takes over the handheld serial port, you must disable it before connecting
the Logitech
®
KeyCase
™
. If not, the handheld may attempt to synchronize when you first use the KeyCase
™
.
6. On the Palm ™ handheld, tap the Logitech ® icon to launch the driver software, then click “Done” after the Tips
have displayed.
7. Turn off the Palm ™ handheld and connect it to the Logitech ® KeyCase ™ , as described in the next section.
Connecting/Removing the KeyCase
™
1. Remove the case strap as shown in picture A.
2. Unfold the KeyCase ™ and lay it flat as shown in
picture B.
3. Attach the Palm
™
V Series or Palm
™
m500 series
handheld to the KeyCase ™ as shown in pictures C and
D. For a Palm ™ m100 Series connection, go to step 4.
A
B
The KeyCase
™
and PDA stand should be
lying flat.
Line up the connector on the handheld
with the PDA stand connector.
Press the handheld onto the PDA stand connector.
The handheld should snap into place.
Raise the handheld and PDA stand into an upright
position.
Secure the PDA stand by placing the bottom end
of the stand against the ridge.
If you have followed the steps correctly,
the handheld will turn on.
Your handheld is now ready to use with
the KeyCase
™
. If the KeyCase
™
goes to
“sleep,” or is powered off in this position,
press any key to activate it. After it
wakes, the next key you press will type.
C
D
E
F
Removing the Handheld from the PDA Stand
The KeyCase
™
and handheld should be lying flat.
Carefully press the handheld toward the base
of the PDA stand and at the same time lift the top end
of the handheld to release it from the PDA stand.