Logik LWC25S10, Инструкция по эксплуатации

Страница: 7 / 16

GB-7
Bef
or
e
U
se
Oper
ation
Specifica
tion
Cleaning
and
M
ain
tenanc
e
Saf
et
y
W
ar
nings
Operating Instructions
Switching On Your Wine Cooler
1. The internal temperature of your wine cooler is
controlled by a thermostat. There are 7 settings, of
which position 7 is the coldest and position 0 turns
the wine cooler off.
2. Make sure that the Thermostat Control Dial, located
inside the wine cooler on the right hand side is set
to 7.
3. After the wine cooler has been on for 20 minutes
adjust the Thermostat Control Dial to 5 – 6.
This is the recommended setting for the
wine cooler when operating at normal room
temperature (between 16°C and 32°C).
4. The wine cooler may not operate at the correct
temperature if it is in a particularly hot or a
particularly cold room, or if you open the wine
cooler door often.
5. If you are concerned that your wine cooler is not
being kept cold enough and wish to check the
temperature you will need a special wine cooler
thermometer. You may also need a hygrometer to
check the humidity of your wine cooler. These are
available from most supermarkets and hardware
shops.
Place the thermometer and hygrometer on the
middle shelf of the wine cooler, where they can be
read easily. Leave overnight, the temperature in the
wine cooler should be between 5°C and 20°C and
the humidity in the wine cooler should be between
50%-80% RH depending on the type of wine.
6. In the 0 position the wine cooler will not operate,
but the power supply remains connected.
2
3