14
Installation
17. Make sure your plumbing is suitable for use
with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS using the
new water supply hose. OLD HOSE SETS MUST
NOT BE RE-USED. The water pressure from the
water mains needs to be at a minimum of 0.03
MPa and a maximum of 1.00MPa.
• Connect one end of the water supply hose to
your dishwasher, and then connect the other
end of the hose to your water mains. Please
ensure the black rubber seal is in place.
• After connecting the hose, turn on your water
mains and check for leaks.
• Connect the dishwasher to the mains socket.
water mains
Y-Adaptor
(not included)
Connect
to another
appliance
if required.
safety water supply hose
16. Cut out a 450 mm wide slot from the plinth so
the unit door can fully open downwards. The
depth of the cut out should be sufficient to
allow the door to open fully and will depend
on the thickness of the panel fitted to the
door.
• Do not bend or kink your drain hose.
* All images are for reference only; please refer to your individual unit for actual item.
You may use a Y-adaptor (not included)
for an additional water feed for another
appliance, for example a washing
machine. This is only applicable to
the cold water mains. A Y-adaptor is
available from most DIY stores.
Logik Integrated Diswasher LID45W18 Manual.indd 14
07/12/2018 12:12