Logik LF674SSN, Инструкция по эксплуатации

Страница: 17 / 21

15
Never run the dishwasher without the filters in place.
If your dishwasher is left in an unheated place over the winter, ask a service technician to:
It is necessary to clean the spray arms regularly for removing the accumulation of scale
for the hard water and thus prevent blocking of spray arm jets and bearings. To remove
the spray arm, screw off the nut to take out the washer on top of the spray arm and remove
the arm. Wash the arms in soapy and warm water and use a soft brush to clean the jets.
Replace them after rinsing them thoroughly.
1
Close
2
3
Filter assembly
For best performance and results, the filter assembly must be clean regularly. The filter
efficiently removes food particles from the wash water, allowing it to be recirculated
during the cycle. For this reason, it is a good idea to remove the larger food particles
trapping in the filter after each wash cycle by rinsing the semicircular filter and cup
under running water. To remove the filter assembly, pull on the cuphandle in the
upward direction. The entire filter assembly should be cleaned once a week. To clean
the coarse filter and the fine filter, use a cleaning brush. Reassemble the filter parts as
shown in the figures left and reinsert the entire assembly in the dishwasher, positioning
in its seat and pressing downward. The dishwasher must never be used without the filters.
Improper replacement of the filter may reduce the performance level of the appliance
and damage dishes and utensils.
1. Cut off electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water supply
hose from the water valve.
3. Drain water from the water supply hose and water valve.
(Use a pan to catch the water.)
4. Reconnect the water supply hose to the water
valve.
5. Remove the filter in the tub at the bottom and use a
sponge to soak up water in sump.