6
Installation
• This oven must be installed in compliance with local safety regulations.
• Wiring connections must be in accordance with Local Wiring Rules and any particular conditions of the
local authority.
• Refer to the data plate for rating information. The data plate is positioned at the rear of the oven. The wiring
diagram is positioned on the rear panel of the appliance.
• A means of disconnection with a contact separation of at least 3mm must be supplied in the fixed wiring.
If this does not exist a qualified electrician will need to fit one.
• This appliance must be properly earthed.
• Do not lift the appliance by the door handles.
• Prepare the cupboard opening to match your appliance measurements. (See diagrams)
• Slide appliance into the cupboard, ensuring that the mains cable (where fitted) does not kink.
• To prevent tipping, secure your oven into the cupboard or bracket by fastening with the 4 screws supplied.
• The cabinet must be suitable for use with built-in ovens and capable of withstanding 100°C. Installation into
low temperature tolerant cabinetry (e.g. Vinyl coated) may result in deterioration of the low temperature
coating by discolouring or bubbling.
• Ensure the cabinet is rated at a temperature suitable for built in ovens. We cannot accept responsibility for
damage caused by installation into low temperature tolerant cabinets.
• After installation, test and ensure that the appliance operates correctly.
To avoid any potential hazard, you must follow these instructions when you install your appliance.
• The electrical connection of this oven should be carried out by a qualified electrician.
Following the instructions in the installation section of this manual and in compliance with
the current regulations.
• The oven is intended for household use only.
LBUDOX16_IB.indd 6
09/06/2016 14:16
