Logik L614WD13, Инструкция по эксплуатации и монтажу

Страница: 25 / 32

25
There’s not much foam • This can happen if you’ve put powder detergent directly into
the drum – you must put it in the detergent drawer.
• The amount of foam can vary, depending on the temperature,
level and softness of your water.
• You may not be using enough detergent.
• You may be using a reduced-foam type of detergent.
• Heavily soiled laundry can reduce the amount of foam.
• Larger loads of laundry can also reduce the amount of foam.
There’s a lot of foam • The amount of foam can vary depending on the temperature,
level and softness of your water.
• You may have used too much detergent.
• The type of detergent you use could cause excess foam.
There’s no foam • This can happen if you’ve put powder detergent directly into
the drum – you must put it in the detergent drawer.
• If your laundry has collected to one side of the drum, water
will be supplied automatically to correct the imbalance – and
this will prevent the foam wash.
• The amount of foam can vary, depending on the temperature,
level and softness of your water.
Fabric softener overflows • You may have exceeded the MAX level in the softener drawer.
• You may have spilt the liquid by closing the softener drawer
too firmly.
There’s a residue of
powder detergent at the
end of the wash
This can happen if you’ve put powder detergent directly into the
drum – you must put it in the detergent drawer.
There’s an unusual noise
or vibration
• Check there’s nothing metal in the drum.
• Make sure the transit bolts used in transportation have been
removed.
• Check the washing machine is on a flat, stable surface.
There’s a noise when the
water drains away
This is normal, it’s the pump starting and stopping.
The electricity supply cuts
out while the washing
machine’s on
The washing machine will stop, and won’t start by itself when
the power comes back on. You’ll need to select a programme and
start it again.
A circuit breaker trips the
electricity supply
• The washing machine will stop, and won’t start by itself when
you reset the breaker.
• You’ll need to find out what caused the breaker to trip, and
put this right. Then reset the breaker, turn your electricity
supply back on, and start the washing machine again.
The water supply is
disrupted
When the water comes back on, it may be impure at first.
You’ll need to disconnect the water-supply hose and drain
any impure water through the tap before using your washing
machine again. Remember to re-connect the water supply hose
first.