Logik L614WD13, Инструкция по эксплуатации и монтажу

Страница: 27 / 32

27
Display Fault What to do:
Heating malfunction
(display after
procedure operation).
Ask a qualified service agent to repair it.
Water intake
malfunction.
Check the water pressure is too low or water
supply is cut off.
Motor malfunction. Contact your qualified service agent.
Water overflow. Ask a qualified technician to repair it.
Drying temperature
sensor malfunction.
Ask a qualified technician to repair it.
Water level sensor
malfunction.
Ask a qualified technician to repair it.
Drying water level
sensor abnormity.
Check if clothes are dried or not, and whether
there is water in the machine. Dry again after
drying programme is finished.
Dryer malfunction. Contact your qualified service agent.
Dryer motor
malfunction.
Contact your qualified service agent.
Washing machine has
an unbalanced load
protection function.
When unbalanced
weight is greater than
allowable maximum,
the washing machine
will not spin and will
run at a low speed
to avoid abnormal
vibration and noise.
• In case washing 1 piece of laundry (carpet, bed
sheet, table sheet, etc) make it symmetrical inside
the drum.
• Lower the wet weight of laundry pieces by
wringing manually and placing them back in the
drum in symmetrical position.
• Take out and then reposition the laundry pieces
inside the washing machine in a more balanced
position on the inner wall of the drum.
• Add 1 or 2 pieces of laundry into the drum to
reduce the unbalanced load effects.
• Restart the spin cycle by choosing Spin
programme.
In case the failure persists, please ask a qualified
technician to repair it.
Electronic fault. Please contact a qualified service agent.