Charging your i-Station Bluetooth2
Note: In order to recharge the i-Station Bluetooth2, please ensure the Main Power Switch (located on
the back of the unit) is in the ON position.
The i-Station Bluetooth2 has a built in rechargeable li-on battery, it can be recharged in two ways :-
1. Connecting the USB charge cable to an available USB port (PC/Mac or with an Optional Dual USB Power
Adapter - see our Spare Parts List at the end of this manual)
Once the i-Station Bluetooth2 is fully charged the LED will revert back to the previous LED status (i.e. if the
speaker was in a playing status during charging, the LED will illuminate BLUE)
The Bluetooth speaker can also be used when the unit is recharging.
Paring the i-Station Bluetooth2 with a Bluetooth Device (First time connection)
1. Ensure the i-Station Bluetooth2 is fully charged or that the i-Station Bluetooth2 is connected to a power
source.
2. Turn the main power switch located at the back of the i-Station Bluetooth2 to the ON position.
3. Activate your Bluetooth device to the Searching mode (new device searching)
4. Press and hold the ‘Stand-by’ button on the side of the i-Station Bluetooth2 until the Red/Blue LED starts
flashing on front of the i-Station Bluetooth2. (i-Station Bluetooth2 will have 3minutes to connect/pair with your
Bluetooth).
5. ‘Logic3 BT196’ will appear on your Bluetooth device.
6. Select ‘Logic3 BT196’ and enter ‘0000’ for the passcode if necessary.
7. LED on front of the Speaker will stop flashing and a tone will sound to acknowledge successful paring.
8. Check your Bluetooth device to ensure that connection is successful.
Note: If after 3minutes no connection is made the speaker will sound and the LED will turn OFF.
Operation of i-Station Bluetooth2 (Device Dependant)
1. Ensure the i-Station Bluetooth2 is fully charged or that the i-Station Bluetooth2 is connected to a power
source.
2. Turn the main power switch located at the back of the i-Station Bluetooth2 to the ON position.
