Compact Elite Mat Cutter
Instruction Manual
Model 350-1
3
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com
Left
Right
Top
Bottom
Fig. 1
Blade Installation - Model 302 Bevel Cutter
1. Remove blade knob.
2. Remove one blade from the package of five.
NOTE:
Because the blades are packed with a small amount of oil, they may stick
together. Be certain that only one blade is being inserted into the blade slot.
3. Place blade onto blade holder, sharp edge down and slide blade until
corner of blade tip enters slot and hole in blade lines up with hole in
blade holder
(Fig. 2) (Fig. 3)
.
4. Replace blade knob and tighten.
NOTE:
Blade holder has a spring that is designed to keep blade safely withdrawn
when not in use. It is not designed to pull blade out of mat after cutting.
Blade Installation - Model 701-1 Straight Cutter Elite
1. Remove blade knob and blade cover.
2. Align blade hole over thread. Be sure sharp edge of blade is facing down.
3. Reassemble blade cover and blade knob.
NOTE:
Adjust blade to foamboard (fully extended), standard mat board (middle
setting) or safety (fully retracted)
(Fig. 4)
.
Measuring Bar & Stop Installation
1. Align pin in bottom of measuring bar with hole on bar and press to install
(Fig. 5)
.
2. Slide stop onto guide rail
(Fig. 5)
.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Orientation
The procedures detailed in the
following instructions refer to the
right & left sides and top & bottom
of the machine as shown
(Fig. 1)
.
