LOFTNESS FertiLogix F1210, Руководство пользователя и каталог запасных частей

Страница: 32 / 92

24 12 Ton Spreader OM
Spread Pattern Test
Before placing the fertilizer spreader into operation, a
spread pattern test must be performed. Differences
in product density and/or texture can vary a spread
pattern, therefore a test must be performed each time a
new material is implemented. Certain variables must be
controlled and adjusted to ensure that there is uniform
product coverage and that the spreader is operating
efficiently with optimal performance.
Loftness is not responsible for costs or damages
caused by misapplication of fertilizers. It is the
responsibility of the operator to assure that the
fertilizer is applied uniformly and correctly over the
application area.
NOTE: A spread pattern test must also be performed
at the beginning of each season, and after
adjustments have been made.
Machine Preparation
Ensure the following items are completed before
performing the spread pattern test.
• Inspect, repair, or replace any components that are
damaged or not performing properly.
• Make all of the adjustments indicated in this manual.
• Ensure rear end and spinners are clear and free of
obstruction.
• Determine the weight per cubic foot of material to
be spread as accurately as possible using a density
scale. See Loftness part number N105370.
• Fill the hopper 40-50% of full capacity. There must
be enough product added to ensure the gate is
completely covered throughout the test.
• Set the machine to the appropriate RPM. Refer to
“Spinner RPM” on page 29 for instructions. Chart
shows recommended spinner speeds and blade
setting for desired driving intervals. Adjustments to
spinner speed/blade settings may be required to
optimize spread pattern.
Course Set-up
You will need:
• Density scale
• 17 identical collecting pans lined with dividers
• 3 flags
• Yellow rope
• 17 cone-bottom vials with rack
• Funnel
NOTE:
For a test pattern kit with these items, contact
your dealer.
Set-up and Operation